Introduction To The Installation Method Of The Direct Drinking dispenser

water purifier

Now we can often see drinking fountains, water purifiers, direct drinking fountains and so on in our lives. So let’s take a look today about how to install the water dispenser correctly.

Installation note

Points to note for installation of direct drinking fountains: In order to ensure that the direct drinking fountains products meet the needs of customers, the installer should ensure that the inlet water quality, inlet pressure, inlet water flow, and water temperature of the water purifier meet the requirements in the product performance parameter table. If the quality of the influent water is not municipal tap water, you need to add a pre-filter device in front of the water purifier. If the inlet water pressure is too high (more than 3 kg), you need to install a pressure reducing valve in front of the water purifier. If the inlet water pressure is too small (less than 1 kg), you need to install a booster pump in front of the water purifier.standing water dispenser

When the water purifier needs to be installed in front of a heating device such as a water boiler, ensure that the installation position of the water purifier is lower than the position of the water boiler to prevent the steam in the water boiler from entering the water purifier and damaging the filter element of the water purifier. In addition, all wading accessories such as pipelines, joints, and faucets on the water purifier should comply with national sanitary standards. However, the direct drinking fountain should not be installed outdoors in the north to prevent freezing and cracking of the ultrafilter element, and at the same time, it should be protected from direct sunlight. Do not use too much force when installing the straight water dispenser to tighten the threaded joint, in order to prevent the joint thread from slipping.desktop water dispenser

Check the water inlet pressure; install the water purifier tap (optional); connect the water inlet, water purifier, and sewage outlet pipes; fix the water purifier; check the use of the water purifier after installation, and check the connection pipes. There are three ways to connect the drain outlet of the direct drinking water machine when installed in the cabinet: drill a hole on the countertop of the cabinet, and install a 4-point faucet to connect to the drain outlet of the water purifier product. Instead of drilling holes on the countertop of the cabinet, replace the original faucet with a specially designed 2-pipe faucet. The second pipe is connected to the purified water outlet of the water purifier, and the fourth pipe is connected to the sewage outlet of the water purifier. Do not drill holes on the countertop of the cabinet, install a ball valve at the sewage outlet of the water purifier, or lead the sewage outlet to the drain pipe. Finally, it should be noted that the right amount of raw material tape (also known as water tape) should be wrapped around the outer teeth to avoid water leakage or cracking. Second, when installing the O-ring seal, check whether the seal ring is damaged or twisted. Third, do not use too much force when tightening the outer teeth straight through, otherwise it may cause thread slippage.RO water cooler


Post time: Jun-01-2022